With the improvement of people’s living standards, the market’s demand for flour and other flour products has been on the rise. Many families have begun to use a variety of special flour to bake bread or cakes, but at the same time, the demand for flour has become even higher. High, not only has strict requirements on the taste, whiteness and safety of flour, but also regards the fineness of flour as an important measurement standard. Therefore, in flour production and related standard requirements, there will be A test item such as the thickness of the powder was measured using a circular pulverizer.
At present, under the requirements of related standards and markets, as well as the stricter control requirements of production companies for their own products, more and more companies have applied circular test screens to measure the thickness of powders. The frequency of application of powder screening has also increased accordingly. In the process of use, there is a problem that users ask us about, that is, they can run together, but the noise is too high. To top this phenomenon, Top Cloud Yunnong The technical staff also conducted some analysis of the reasons. The most likely reasons are the following three points.
1. There are one or more loose screws in the three-bar linkage. Although it is more basic and simpler to tighten the screw, it is also easy for the user to ignore during the operation. There are many users before. Forget the phenomenon of tightening the screw and can not be used, so if there is a phenomenon of excessive noise in the operation of the circular powder test sieve, first check whether the screw is loose, and if it is tightened, it can be solved.
2. After a period of use, the small clearance of the connecting rod small bearing E18 increases. In the process of using the small bearing of the connecting rod, the gap will increase with the increase of the running time, and the noise will also cause too much noise. If this happens, timely replacement of the small connecting rod bearing can be solved.
3. After a period of use, the inner diameter of the connecting rod bearing housing becomes larger and should be replaced. As the connecting rod bearing seat and the small connecting rod bearing are components that are easily lost, the connecting rod bearing housing will increase with the use of time. The inner diameter becomes larger, so that noise occurs. Therefore, if it is not the above two cases, it can be checked whether the inner diameter of the connecting rod bearing housing becomes larger, and if so, replace it in time.
as an expert industrial fan heaters factory, indunstrial heaters including PTC fan heaters, Ceramic fan heaters & Copper fan heaters
If you want to heat a small area or are offering spot heating in your garage, greenhouse or Garden, consider a Industrial Heater. You can also consider fan-forced heaters. industrial heater with IP24, it can be use outdoor and indoor. and the power is bigger than household use one. like 2kw, 3kw,5kw,9kw,12kw industrial fan heaters. more level of power for your choice.
Welcome to order industrial heater, first choice is industrila fan heaters.
thanks
Industrial Heater Blower,Industrial Electric Fan Heaters,Industrial Gas Heater Blower,Electric Blow Heaters Industrial
Fenry Manufacturing Co., Ltd , https://www.fenry-fan-heater.com