The structure of the impact crusher is shown in the figure above. The working principle of the impact crusher is: the ore enters the hammer strike zone from the feed port along the guide plate, and there are two different situations after the impact is broken. The small piece of material is thrown in the tangential direction after being impacted by the hammer; The material is thrown at an angle to the tangential direction due to the eccentric impact. The material is thrown at high speed to the counterattack plate, again subjected to impact crushing, and then rebounded from the counterattack plate back to the hammer strike zone, and the above-mentioned crushing process is repeated, and the ore collides with each other during the round trip between the hammerhead and the counterattack plate. effect. Because the ore is subjected to multiple impacts of the hammerhead and the counterattack plate and collision with each other, the ore is continuously cracked, loose and broken along its joint interface. When the crushed ore has a particle size smaller than the gap between the hammer head and the counterattack plate, it is discharged from the lower part of the machine, that is, the broken product.
The hammerhead of the impact crusher is fixedly mounted on the rotor, has a counter-attack device and a large crushing space. When crushing, it can fully utilize the energy of the entire rotor, and the crushing is relatively large, and can be used as a coarse, medium and fine crushing device for ore.Water To Air Heat Pump
Cooling capacity 2.5kW-45kW
Advantage: Packaged type water to air heat pump to save space; High efficiency; Installation very easily and low noise. Split type water to air chiller (optional).
Characteristics
1.Structure. Panels and frame are made from galvanized steel protected with polyester powder painting to ensure total resistance to atmospheric agents.
2.Hermetic compressor. Rotary type compressor for model 2.5 to 12, and scroll type compressors for model 14 to 45, with built-in thermal overload cut-out and crankcase heater, mounted on rubber vibration dampers.
3.Centrifugal fan. Low noise; Protection level IP44
4.Water side heat exchanger. High efficiency tube in tube heat exchanger, factory insulated with flexible close cell material.
5.Refrigerant circuit. Copper tube connection with charge valves, filter, capillary tube; high pressure switch and low pressure switch. The heat pump units are complete also with 4-way valve and one way valve.
6.Electric panel. Consists of:
Compressor contactor
Compressor protection breaker
Microprocessor with function display
Water To Air Heat Pump
Water To Air Heat Pump,Water to Air Heat Pump Chiller,Water to Air Heat Pump Unit,Water Loop Heat Pump Chiller
Jinan Amrta Air Conditioning Co.,Ltd , https://www.waterchiller.pl